follow these steps to creat your own grids for badges and sponsors
INSTRUCTIONS FOR USING PSP
how to resize an image
when the image is loaded, click "SHIFT" + "S"
now resize the image to the required pixel dimentions
pixel directions for the badge
Width - 64
Height - 48
MAKE SURE THIS IS PIXEL SIZE
now how to get the grid and grid size
now on the toolbar with file, edit ect. go to "View" >>>>> "Change Grid, Guide & Snap Properties"
now change the current image settings to 1 on both horizontal and vertical grids.
MAKE SURE UNITS ARE PIXELS
Click OK
Now Click "CTRL" + "ALT" + "G"
you should now have a grid pixel by pixel, to get a good outcome is to zoom in between 1000 and 3000 percent.
Instructions For PAINT
to resize a image
To change the size of your picture
On the Image menu, click Attributes.
Under Units, click the unit of measurement as PIXELS for the width and height.
Type the measurements in Width and Height.
for badge
Width - 64, Height - 48
To Show Gridlines
On the View menu, point to Zoom, and then click Custom.
Under Zoom to, click the percentage of zoom as 800% or greater if available, and then click OK.
On the View menu, point to Zoom, and then click Show Grid.
NOW NOBODY CANNOT TRY THIS, AND EVERYBODY CAN DO KITS IF YOU FOLLOW THESE INSTRUCTIONS, IF AVAILABLE USE PSP OR ANOTHER PROGRAM OTHERWISE USE PAINT